Limitations of Bifurcation Diagrams in Boost Converter Steady-State Response Identification

Authors

  • Željko Stojanović Zagreb University of Applied Sciences Department of Electrical Engineering Konavoska 2, 10000 Zagreb, Croatia
  • Denis Pelin Josip Juraj Strossmayer University of Osijek Faculty of Electrical Engineering, Computer Science and Information Technology Osijek Kneza Trpimira 2B, 31000 Osijek, Croatia

DOI:

https://doi.org/10.32985/ijeces.8.2.3

Keywords:

bifurcation diagram, boost converter, identification, sampling, steady-state responses

Abstract

Steady-state responses of the boost converter operating in discontinuous conduction mode of operation are identified by using bifurcation diagrams as a typical simulation tool for identification of steady-state responses. The structure of simulated bifurcation diagrams is dependent on the initial period of sampling and the initial instant of sampling. The influence of these parameters on calculation of bifurcation diagrams was studied. Some possible issues, pitfalls and misinterpretations are commented as well as some recommendations about steady-state response identification are given.

Downloads

Published

2018-01-27

How to Cite

[1]
Željko Stojanović and D. Pelin, “Limitations of Bifurcation Diagrams in Boost Converter Steady-State Response Identification”, IJECES, vol. 8, no. 2, pp. 59-65, Jan. 2018.

Issue

Vol. 8 No. 2 (2017)

Section

Preliminary Communications